Tacoma Bed MOLLE System: Front vs Bed Side Panel Setup
By Body Armor 4x4 | Published: 2026-11-04
Category: 比較
Compare the Tacoma front bed MOLLE system and bed side MOLLE panel on mounting position, accessory space, and installation to choose the right cargo organization for your truck.
Quick answer
Choose the front bed MOLLE system if you want a single wide mounting wall across the front of the bed for larger accessories like a Hi-Lift jack or Rotopax containers. Choose the bed side MOLLE panel if you need storage along the bed wall and want to keep the front bulkhead clear.
Mounting position changes what you can reach and carry
The front bed panel sits on the bulkhead behind the cab, giving you one broad surface that stays out of the way of everyday bed loading. That position suits long, heavy items such as a jack or fuel container because they sit forward and low in the bed.
The bed side panel runs along the inner bed wall, so it uses vertical space near the wheel well. That makes it easier to grab smaller items from the side of the truck, but it can interfere with cargo that slides against the wall or with bed accessories already mounted there.
One panel versus two: plan for coverage
The front system covers the full width of the bulkhead in one unit, so you get a continuous mounting area without gaps. The side system is sold as a single unit, which means you can start with one side and add a second later if you want matching coverage on both walls.
Decide whether you want a single large mounting zone or the flexibility to build out the sides over time. Buying two side panels costs more than one front panel at catalog prices, so budget for the layout you actually need rather than assuming you will add the second later.
Installation is bolt-on for both, but access differs
Both panels use a bolt-on installation and 3mm formed steel construction, so the main difference is where you work. The front bulkhead is usually easier to reach from inside the bed, while the side wall may require working around the wheel well and any existing bed liner or rail.
Check your bed configuration before ordering. The catalog does not list separate option types or a full hardware breakdown, so confirm the mounting points on your specific truck and whether your bed liner needs trimming.
Trade-offs to weigh before you buy
- Front panel: wide continuous surface: The front system gives you one full-width mounting wall for larger items like a Hi-Lift jack or Rotopax containers, but it puts everything at the front of the bed where it is harder to reach from the tailgate. Measure reach from your tailgate before mounting frequently used gear up front.
- Side panel: flexible but sold singly: The side panel adds storage along the bed wall and can be duplicated for both sides, but a single unit leaves one wall bare and two units cost more than the front panel. Decide whether you need one side or both before ordering.
- Shared installation limits: Both are bolt-on 3mm steel panels, but the catalog does not list hardware or option types, so confirm your bed liner and existing accessories will not block the mounting points. Test-fit the mounting area before you commit to a layout.
Product facts at a glance
- 2005-2023 TOYOTA TACOMA FRONT BED MOLLE SYSTEM: 3mm formed steel front bed MOLLE system with a two-stage light texture black powder coat finish. The steel construction and coating suit a forward-mounted wall that carries heavier accessories and sees weather.
2005-2023 TOYOTA TACOMA FRONT BED MOLLE SYSTEM - 2005-2023 TOYOTA TACOMA BED SIDE MOLLE SYSTEM (SINGLE UNIT): Single-unit bed side MOLLE system in 3mm formed steel with bolt-on installation. One panel lets you add side storage without committing to both walls at once.
2005-2023 TOYOTA TACOMA BED SIDE MOLLE SYSTEM (SINGLE UNIT)
Which setup fits your Tacoma?
Best for
- Drivers who want a single wide wall for a jack, fuel container, or MOLLE bags at the front of the bed
- Owners who want to keep the bed sides clear for sliding cargo
Not for
- Drivers who need frequent side access to smaller tools and want to start with one panel
- Owners who plan to mount gear on both bed walls and prefer to build coverage in stages
